Channel Tuning: Further Information
fig 1
KEY CONTROLS
A – POWER KEY
B – ARROW KEYS
C – OK/ ENTER KEY
D – MENU KEY
E – SOURCE KEY
A
B
D
E
o
C
1. Ensure the TV is in TV mode – press the SOURCE key
(E) and use the UP or DOWN key (B) to select TV
from the source main menu - press the OK key (C) to
confirm.
2. Press the MENU key (D) – the Main Menu appears
on screen. Use the DOWN key (B) to select the
“Setup” screen (4
th
icon down)
3. Press the RIGHT key (B) to enter the Setup menu and
then use the DOWN key (B) to highlight the “Wizard”
option.
Restarting the Tuning Wizard
As stated, the Tuning Wizard (on previous page) should
ensure that you successfully tune all Digital and Analogue
services available to you. If for some reason there are
channels missing or ordered incorrectly please check aerial
cable is connected and restart the Tuning Wizard.
You can also perform a manual channel scan from the TV
main menu to re-tune all channels – please see the
instructions for this below.
RESTART THE TUNING WIZARD.
OK
UP
KEY
DOWN
KEY
RIGHT
KEY
LEFT
KEY
6
4. Use the LEFT or RIGHT key (B) to switch the “Wizard”
On/ Off option to “On” – see fig 2.
5. Use the MENU key (D) to close the Main Menu.
6. Now turn the TV off into Standby – press POWER (A).
7. Wait 3 seconds.....
8. Use the POWER key (A) to switch on the TV.
9. The Initial Setup - Welcome message will appear.
fig 2
OSD Setup ║►
DPMS On ◄►
Source Labels ║►
Wizard On ║►
Time Setup ║►
Subtitle ║►
Teletext ║►
Reset Default ║►
Enter
Select
Exit
ENTER EXIT◄►▼▲
Setup
Follow the instructions on the previous page to perform
the Initial Setup again.
CHANNEL SCAN TUNING (Alternative Option)
1. Press MENU (D) on the remote.
2. Use the ARROW keys (B) to Navigate to the TV
submenu – (3
rd
icon down)
3. Use the ARROW keys to select the “Channel Scan”
option in this menu.
4. Press the RIGHT ARROW key (B) or OK key (C) to
start tuning – see fig 3 above.
5. A progress bar will be displayed as well as the
number of Digital and Analogue services found.
This will take a few minutes to complete.
6. When 100% complete a TV picture will be
displayed – use the MENU key (D) to exit .
Country United Kingdom ║►
LCN Enable On ◄►
Audio Channel Stereo ◄►
Channels ║►
Analogue Manual Scan ║►
Single RF Scan ║►
Channel Scan ║►
Auto Volume Control Off ◄►
Common Interface ║►
Enter
Select
Exit
ENTER EXIT◄►▼▲
TV
fig 3
Service Number 0845 293 7697
(4 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais